Advertisement
Attach two joint bolts M3x9 078 with rich
Loctite on the two free arms of the swash
plate D630. The swash plate guide D530
is already factory mounted with Loctite.
Attach two threaded blocks D23a with two
hex bolts M3x8 using Loctite at the tail-
servo cut-out of the upper left side frame
D601. Add for perfect corresponding holes
a second screw in the block before you
tighten the first one. After tightening remo-
ve the second one.
Place a frame connector D622 between
the lower rear mounting holes of the roll
servos and fix is provisorically on one side
with a hex bolt (no Loctite).
Place the left roll servo. The servos should
have grommets with 3mm brass inserts.
If not you can use optional inserts, f.e.
D153.
Advertisement
