Advertisement
...and another ball bearing 5x10x4 942 fol-
lowed from another washer shim 7x10x0,2
054.
Add the thrust bearing 5x10x4 112. Begin
with the non marked grooved shim with
the inner diameter 5.2mm (tilts) and add in
the groove a bit of lubrication.
Now push the ball cage on as shown and
add also a bit of lubrication on the balls.
Then add the blue marked grooved shim
with the inner diameter 5.0mm (does not
tilt). The outside should correspond with
the end of the tailrotor hub D255.
Advertisement
