Advertisement
... and turn it 90 degree to the right.
The tail gear housing D246 is attached
with the rudder fin holder D44 and the two
bracket mounts D43a with two hex bolts
M3x10 D328 using Loctite. Check that the
bolts are still as loose as possible to fit
easily with the tailboom.
Push the tailrotor housing fully on the
boom and check, looking inside, that the
boom has really mechnical contact to the
end of the housing. Check also that the
brackets are vertical in the boom. Then
tighten the bracket screws.
Push the tailboom as far as possible in
the mechanics so that the tailbelt is as
long as possible out of the tail housing.
Then place the tail belt wheel 20T D643 in
the belt end in that way that the mounting
threads are on the left side (seen in flight
direction).
Advertisement
