Antenna Settings - Siemens SIMATIC NET SCALANCE W760 Series Configuration Manual

● "SNMP" drop-down list:
Select the protocol from the drop-down list. The following settings are possible:
– "-" (SNMP disabled)
– SNMPv1/v2c/v3
– SNMPv3
● "SNMPv1/v2 Read-Only" check box
Enable or disable write access to SNMP variables with SNMPv1/v2c.
● "SINEMA Configuration Interface" check box
If the SINEMA configuration interface is enabled, you can download configurations to the
device via the TIA Portal.
5.3.1.5

Antenna Settings

Introduction
On this Basic Wizard page, you configure the settings for the external antenna.
Description
This table contains the following columns:
● Connector
Shows the name of the relevant antenna connector.
● Antenna Type
Select the type of external antenna connected to the device. If the type of your antenna is
not available, select the entry "User defined".
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
Configuration Manual, 11/2014, C79000-G8976-C350-03
Access to device parameters via SNMP is not possible.
Access to device parameters is possible with SNMP versions 1, 2c or 3. You can
configure other settings in "System > SNMP > General".
Access to device parameters is possible with SNMP version 3. You can configure
other settings in "System > SNMP > General".
Configuring with Web Based Management
5.3 "Wizard" menu
47