Siemens SIMATIC NET SCALANCE W760 Series Configuration Manual page 187

With Table 2, you can enable or disable all check boxes of a column of Table 3 (Data Rate)
at once. Table 2 has the following columns:
● All data rates settings
Shows that the setting is valid for all entries of Table 3.
● Enabled / Basic
In the drop-down list, select the setting for all entries. If "No Change" is selected, the entry
in Table 3 remains unchanged.
● Copy to Table
If you click the button, the setting is adopted for all entries of Table 3.
Table 3 (Data Rate) consists of the following columns:
● Radio
Specifies the WLAN interface to which the information relates.
● Data Rate [Mbps]
Shows the supported data transmission speeds in megabits per second.
● Enabled
Enable the option to assign the required data transmission speed to the WLAN interface.
Note
You need to enable at least one data transmission speed.
● Basic
Enable the option to declare the required data transmission speed as "Basic". The "Basic"
parameter specifies that a client must be capable of this speed to be able to connect to
the access point. The "Basic" option can only be enabled if an available data transmission
speed has been selected.
Note
At least one data transmission speed needs to be specified as "Basic".
Button "Default Values"
The "Default Values" button sets the selection of the values in compliance with the standard.
Procedure
To configure a certain data transmission speed on WLAN 1:
1. Enable the "Use selected data rates only" option for "WLAN 1".
2. From the "Radio" drop-down list, select the entry "WLAN 1".
3. Select the check box in the "Enabled" and in the "Basic" column for the required data
transmission speed.
4. Click the "Set Values" button.
To reset the selection:
1. Click the "Default Values" button. The selection is reset to the default setting.
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
Configuration Manual, 11/2014, C79000-G8976-C350-03
Configuring with Web Based Management
5.6 "Interfaces" menu
187