Dhcp Server - Siemens SIMATIC NET SCALANCE W760 Series Configuration Manual

Configuring with Web Based Management
5.5 "System" menu
5.5.10.2

DHCP server

Note
This tab is available only on the client SCALANCE W722-1 RJ-45.
You can operate the device as a DHCP server. This allows IPv4 addresses to be assigned
automatically to the connected devices. The IPv4 addresses are either distributed
dynamically from an address band you have specified or a specific IPv4 address (static) can
be assigned to a particular device.
On this page, specify the IPv4 address band from which the DHCP client receives any IPv4
address. You configure the static assignment of the IPv4 addresses in "Static Leases".
Requirements for the DHCP server
● NAT is enabled. You enable NAT in "Layer 3 > NAT".
● The connected devices are configured so that they obtain the IPv4 address from a DHCP
server.
134
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
Configuration Manual, 11/2014, C79000-G8976-C350-03