Siemens SIMATIC NET SCALANCE W760 Series Configuration Manual page 126

Configuring with Web Based Management
5.5 "System" menu
Description
The table has the following columns:
● Type
Shows the user certificate
● Description
Shows the short description of the user certificate.
● Enabled
Specifies whether the user certificate needs a password. If you enable the settings,
specify the password in "Password".
● Password
Enter the password for the user certificate.
Note
When assigning the password, ASCII code 0x20 to 0x7e is used.
● Password Confirmation
Confirm the password.
● Status
Shows whether the current settings for the certificate match the device.
– Valid
– Invalid
Procedure
1. Select the "Enabled" option.
2. Enter the password in "Password".
3. To confirm the password, enter the password again in "Password Confirmation".
4. Click the "Set Values" button.
126
The settings are valid.
The settings are invalid.
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
Configuration Manual, 11/2014, C79000-G8976-C350-03