Message - Panasonic AJ-CX4000G Operating Instructions Manual

Message

Screen display
Camera image screen
[CANNOT PLAY.]
[CANNOT DELETE.]
[CANNOT RECORD. THE NUMBER
OF CLIPS HAS EXCEEDED THE
MAXIMUM LIMIT.]
[CARD ERROR. PLEASE
REFORMAT.]
[COPY IMPOSSIBLE. TOO LARGE
CLIP CONTAINED.]
[CANNOT COPY TO SAME CARD.]
[Repair failed.]
[REINSERT OR CHECK CARD.]
[CANNOT PROTECT.]
[THE CLIP IS PROTECTED. PLEASE
CANCEL PROTECTION.]
[CANNOT DELETE UNTIL TOP
MENU IS DELETED. DELETE TOP
MENU? (RECORDED DATA WILL
NOT BE DELETED)]
[CANNOT RECORD UNTIL TOP
MENU IS DELETED. DELETE TOP
MENU? (RECORDED DATA WILL
NOT BE DELETED)]
[THUMBNAIL DATA ERROR IS
DETECTED.]
[CANNOT RECORD -
INCOMPATIBLE CONTROL DATA.]
[CANNOT SET.]
[THIS CLIP CANNOT BE COPIED.]
[CONTROL DATA ERROR HAS BEEN
DETECTED. (SD CARD)]
[COPY FAILED. PLEASE CHECK
THE CARD.]
[COPY TERMINATION IN
PROGRESS DUE TO INSUFFICIENT
BATTERY POWER. DO NOT SWITCH
OFF.]
[COPY TERMINATED DUE TO
INSUFFICIENT BATTERY POWER.]
[CANNOT COPY - THE NUMBER OF
CLIPS HAS REACHED MAXIMUM.]
[LOW BATTERY. PLEASE CONNECT
AC ADAPTOR OR CHANGE
BATTERY.]
[CANNOT PLAY THIS CLIP ON THIS
MODEL.]
[ERROR HAS OCCURRED. TO
REPAIR THE CONTROL DATA,
PLEASE CONNECT AC ADAPTOR
OR CHANGE BATTERY.]
Chapter 10 Maintenance — Warning system
Description
This is a clip that cannot be played back.
(When it cannot be played back due to difference of the
system frequency, etc.)
An error has occurred during playback, and the playback
has stopped.
This is a clip that cannot be deleted.
The number of clips that can be recorded has reached the
maximum.
Formatting of the memory card has failed.
The P2 clip exceeding 4 GB cannot be copied to a
memory card of 32 GB or less.
The clip recorded over multiple memory cards cannot be
copied to a same memory card.
Repairing the clip where an error occurred has failed
because the power was disconnected or the memory card
was removed during recording.
Restoring of the management information has failed.
This memory card cannot be formatted.
This is a clip that cannot be protected.
The clip is protected so it cannot be deleted.
The camera is trying to delete a clip on the memory card
where the top menu has been created.
The memory card where the top menu was created has
been inserted.
An error occurred in the thumbnail information of the
memory card.
The version of the management information on the
memory card is not supported.
This cannot be set.
The clip cannot be copied.
An error occurred in the management information of the
memory card.
The clip has failed to copy due to an error in the memory
card.
Remaining battery level became low while copying the
clip.
Copying of a clip is canceled due to insufficient remaining
battery level.
The number of clips that can be copied has reached the
maximum.
It is trying to copy a clip or update the camera firmware
while the remaining battery level is insufficient.
This is a clip that cannot be played back with the camera.
The remaining battery level was low when the restoring of
the management information is started.
A message is displayed.
f Confirm if the system frequency of the clip is the same as
the system frequency of the camera.
f Check the clip.
A message is displayed.
f Match the device and content versions.
A message is displayed.
f Replace the memory card or delete unnecessary clips.
A message is displayed.
f Format it again.
A message is displayed.
f Copy to a memory card with the capacity exceeding
32 GB.
A message is displayed.
f Copy to a memory card not containing a clip that is
recorded over multiple memory cards.
A message is displayed.
f Check the memory card.
A message is displayed.
f Check the memory card.
A message is displayed.
f Match the device and content versions.
A message is displayed.
f Cancel the protect on the clip.
A message is displayed.
f Delete the top menu.
A message is displayed.
f Delete the top menu.
A message is displayed.
f Restoring of the management information is performed
automatically after this.
A message is displayed.
f Match the device and content versions.
A message is displayed.
f Perform the setting after making it possible to set.
A message is displayed.
f Copy the clips other than the corresponding clip.
A message is displayed.
f Restoring of the management information is performed
automatically after this.
A message is displayed.
f Check the memory card.
A message is displayed.
f The copy is canceled.
f Replace with a fully charged battery, or connect the
external DC power supply.
A message is displayed.
f Replace with a fully charged battery, or connect the
external DC power supply.
A message is displayed.
f Replace the memory card in the copy destination or
delete unnecessary clips.
A message is displayed.
f Replace with a fully charged battery, or connect the
external DC power supply.
A message is displayed.
f Playback on a device that can playback.
A message is displayed.
f Replace with a fully charged battery, or connect the
external DC power supply.
– 206 –
Behavior and cause