Panasonic AJ-CX4000G Operating Instructions Manual page 204

Recording or playback operation
Action to take
6 Recording error
Status display
Warning lamp
Tally lamp
Card access lamp
Viewfinder
Alarm
Warning content
Recording or playback operation
Action to take
7 Card error
Status display
Warning lamp
Tally lamp
Card access lamp
Viewfinder
Alarm
Warning content
Recording or playback operation
Action to take
8 Reduced wireless audio reception
Status display
Warning lamp
Tally lamp
Viewfinder
Alarm
Warning content
Recording or playback operation
Action to take
9 Battery near end
Status display
Warning lamp
Tally lamp
Viewfinder
Alarm
Warning content
Recording or playback operation
Action to take
10 Memory card recording near end
Status display
Warning lamp
Tally lamp
Viewfinder
Alarm
Warning content
Recording or playback operation
Action to take
Chapter 10 Maintenance — Warning system
Recording will stop.
Delete clips in the memory card or insert a new memory card.
Does not display.
Flashes four times per second.
Flashes four times per second.
All card access lamps flash four times per second in orange.
[REC WARNING] is displayed.
f [REC WARNING]/[<OVER MAX NUM. OF CLIPS>] is displayed when you try to record exceeding the limit for number
of clips.
f [TEMPORARY PAUSE]/[IRREGULAR SIG] is displayed when the genlock reference signal is not correctly received.
Sounds four times per second.
This is a recording or recording circuit setting error.
Recording will stop. When the reference signal for genlock is not correctly received, pause the recording, and resume
the recording when the signal returns to normal.
Start recording again. Or, turn the power off once and then start recording again.
To record exceeding the maximum numbers of the clips, replace the memory card or delete unnecessary clips.
Does not display.
Flashes four times per second when occurring during recording.
It does not illuminate when it occurs during playback.
Flashes four times per second when occurring during recording.
It does not illuminate when it occurs during playback.
All card access lamps flash four times per second in orange when occurring during recording.
Displays [CARD ERROR <SLOT 1>] (corresponding card slot number is displayed).
Sounds four times per second when occurring during recording.
It does not sound when it occurs during playback.
A memory card error occurred during recording or playback.
The current operation will stop. The memory card with the error is write-protected after it is stopped.
Replace the memory card.
Does not display.
Flashes four times per second. (When idle or during recording)
Flashes four times per second while recording is continued.
[WIRELESS RF] is displayed.
Sounds four times per second while recording is continued.
The error indicates poor wireless audio reception conditions.
The current operation will continue.
Check the microphone power supply and the reception status of the receiver.
One battery charge level bar flashes.
Flashes once per second.
Flashes once per second.
The [BATT] lamp flashes once per second if the viewfinder has the [BATT] lamp. ([%] indication flashes if the battery has
information of remaining capacity.)
Sounds four times per second.
The battery is about to run out.
The current operation will continue.
Change the batteries as needed.
One remaining memory card capacity level bar flashes.
Flashes once per second while recording is continued.
Flashes once per second while recording is continued.
The remaining memory card capacity indicator flashes.
Sounds once per second while recording is continued.
The remaining memory card capacity totals 2 minutes or less.
The current operation will continue.
Change the memory card or insert an additional card as needed.
– 204 –