Panasonic AJ-CX4000G Operating Instructions Manual page 143

f [!SDXC]: Recording format is set to MOV but SDXC memory card, expressP2 card, or 64 GB microP2 card is not inserted.
f (No display): It is in one of the following conditions.
- A memory card has not been inserted.
- The memory card cannot be recognized.
- It is set to the [NETWORK] menu → [NETWORK FUNC] → [NDI|HX].
7 Message display area for wireless audio warning and cooling fan stop
Displays a warning when the wireless audio reception status becomes poor.
Displays a message when the cooling fan has stopped.
8 SDI/HDMI remote control status
Displays the control status of the recording start and recording stop on the external equipment connected to the <SDI OUT1>/<SDI OUT2>/<HDMI>
terminals.
f [REC S/H]: Recording instruction is output to the output from the <SDI OUT1>/<SDI OUT2>/<HDMI> terminals.
f [S/H]: Pause instruction is output to the output from the <SDI OUT1>/<SDI OUT2>/<HDMI> terminals.
f [REC SDI]: Recording instruction is output to the output from the <SDI OUT1>/<SDI OUT2> terminals.
f [SDI]: Pause instruction is output to the output from the <SDI OUT1>/<SDI OUT2> terminals.
f [REC HDMI]: Recording instruction is output to the output from the <HDMI> terminal.
f [HDMI]: Pause instruction is output to the output from the <HDMI> terminal.
9 Status of card slot 3
It is not displayed when set to the [RECORDING] menu → [REC MEDIA] → [expressP2].
f : Not target for recording.
f (flashing): Recognizing the memory card.
f : Recording target.
f (No display): It is in one of the following conditions.
- A memory card has not been inserted.
- The memory card cannot be recognized.
- The [NETWORK] menu → [NETWORK FUNC] → [NDI|HX] is set.
10 Remaining capacity and status of the memory card in card slot 3
Displays the remaining capacity and status of the memory card in card slot 3.
It is not displayed when set to the [RECORDING] menu → [REC MEDIA] → [expressP2].
f [0min]...[999min]: Displays remaining capacity of the memory card. Remaining capacity of 999 minutes or more is displayed as [999min].
- The display will flash when the remaining capacity of the memory card becomes two minutes or less.
- The remaining capacity of the memory card available for simultaneous recording (remaining capacity for the memory card of the two memory
cards with less remaining capacity) is displayed when simultaneous recording is performed.
f [WP]: It is write protected. The write-protected switch of the memory card is set to the LOCK side.
f [END]: Memory card has no remaining capacity.
f [ERR]: Memory card that cannot record is inserted. Displayed when the card is recognized but cannot be used, such as having a format error, or
not being a memory card.
f [!SDXC]: Recording format is set to MOV but SDXC memory card or 64 GB microP2 card is not inserted.
f (No display): It is in one of the following conditions.
- A memory card has not been inserted.
- The memory card cannot be recognized.
- It is set to the [NETWORK] menu → [NETWORK FUNC] → [NDI|HX].
11 Special recording function
Displays the status of special recording function.
f [INTRVL]: Interval recording is enabled.
f [I-REC]: During interval recording or recording is paused.
f (No display): It is in one of the following conditions.
- Interval recording is disabled.
- It is set to the [NETWORK] menu → [NETWORK FUNC] → [NDI|HX].
12 Two-slot function
Displays the setting status of the recording function using two card slots.
It is displayed with a slanted line if it is in a condition that cannot perform two-slot function even if each function is enabled.
f [RELAY]: Relay recording is enabled.
f [SIMUL]: Simultaneous recording is enabled.
f [NDI|HX]: It is set to the [NETWORK] menu → [NETWORK FUNC] → [NDI|HX].
f (No display): In standard recording status.
13 Flash band compensation function
f [FBC]: Flash band compensation function is enabled.
14 Streaming status
Displays the streaming status.
f : The camera is connected to a device to receive the streaming video, and the streaming video is distributed.
f (flashing): When the camera is trying to connect to a device to receive the streaming video
f : Streaming video is not being streamed.
: There is an error in the streaming function and cannot operate.
f
f (No display): Streaming function is disabled
15 High dynamic range function/dynamic range stretcher function
f [HDR]: It is set to the [SCENE FILE] menu → [GAMMA MODE SEL] → [HLG].
f [DRS]: Dynamic range stretcher function is enabled.
Chapter 5 Shooting — Display of the viewfinder status
– 143 –