Panasonic AJ-CX4000G Operating Instructions Manual page 100

(Factory setting: [DISABLE])
[MULTICAST ADDRESS]
Sets the address when using the streaming with the multicast.
(Factory setting: [239.192.0.20])
[MULTICAST PORT]
Sets the port number when using the streaming with the multicast.
(Factory setting: [37004])
[CLEAR ACTIVATION]
Clears the activation license information that is saved.
The items that can be selected are as follows.
f [YES], [NO]
[LAN PROPERTY]
Sets the wired LAN setting.
[MAC ADDRESS]
Displays the MAC address for the wired LAN of the camera. (Cannot be changed)
[IPv4 SETTING]
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[PRIMARY DNS]
[SECONDARY DNS]
[IPv6 SETTING]
[ENABLE/DISABLE]
[DHCP]
[IP ADDRESS]
[PREFIX LENGTH]
[DEFAULT GATEWAY]
[PRIMARY DNS]
[SECONDARY DNS]
[WLAN PROPERTY]
Performs settings related to the wireless LAN.
[MAC ADDRESS]
Displays the wireless LAN MAC address of the camera. (Cannot be changed)
[TYPE]
Sets the connection method to the wireless LAN.
Chapter 4 Operation — Menu settings
Sets whether to use the automatic acquisition through DHCP or to use the DHCP server function of the camera.
[OFF]: Does not use DHCP.
[CLIENT]: Performs automatic acquisition through DHCP.
The address from 192.168.0.10 through 192.168.0.255 is automatically assigned when the IP address cannot be acquired
automatically within one minute.
[SERVER]: Enables the DHCP server function of the camera.
(Factory setting: [OFF])
Sets the IP address.
f Cannot be set when [LAN PROPERTY] → [IPv4 SETTING] → [DHCP] → [CLIENT] is selected.
(Factory setting: [192.168.0.1])
Sets the subnet mask.
f Cannot be set when [LAN PROPERTY] → [IPv4 SETTING] → [DHCP] → [CLIENT] is selected.
(Factory setting: [255.255.255.0])
Sets the default gateway.
f Cannot be set when [LAN PROPERTY] → [IPv4 SETTING] → [DHCP] → [CLIENT] is selected.
(Factory setting: [192.168.0.254])
Sets the primary DNS server.
(Factory setting: [0.0.0.0])
Sets the secondary DNS server.
(Factory setting: [0.0.0.0])
Sets whether to use IPv6.
[ENABLE]: Uses IPv6.
[DISABLE]: Does not use IPv6.
(Factory setting: [DISABLE])
Sets whether to use automatic acquisition via DHCP.
[OFF]: Does not use DHCP.
[CLIENT]: Performs automatic acquisition through DHCP.
(Factory setting: [OFF])
Sets the IP address.
(Factory setting: [::])
Sets the prefix length of the subnet.
(Factory setting: [64])
Sets the default gateway.
(Factory setting: [::])
Sets the primary DNS server.
(Factory setting: [::])
Sets the secondary DNS server.
(Factory setting: [::])
– 100 –