Playing Back Clips - Panasonic AJ-CX4000G Operating Instructions Manual

@
NOTE
t Do not remove the memory card in the card slot that is flashing, or do not remove the battery or the external DC power supply when the card access
lamp is flashing in orange. Doing so will cause damage to the memory card.
t Use a sufficiently charged battery or external DC power supply.
t It may not be possible to completely repair depending on the condition of the data.
t To restore the clips, it is necessary that the clips are recorded for more than a certain amount of time. Especially in the following cases, the clips may
not be restored, because the number of frames to be recorded is small.
- When the interval recording is enabled.
t The clips shot before the power was turned off will not be able playback if the repair fails.
Also, it may not be possible to record any more.
t If data recorded with other device is repaired, it may not be able to play back on the camera or other device.
t If the repair failed, turn off the camera, and turn it back on after waiting for a while. If the repair fails repeatedly, format with the camera. All data will be
erased when it is formatted, and it cannot be restored.
t Display of the thumbnail become slower when the thumbnail information is repaired.

Playing back clips

1
In the [SYSTEM] menu → [FREQUENCY], select the system frequency to play back.
2
In the [SYSTEM] menu → [FILE FORMAT], select the file format to play back.
3
In the [SYSTEM] menu → [REC FORMAT], select the signal format and codec mode to play back.
4
Press the <THUMBNAIL> button.
The thumbnail screen is displayed.
5
Press the <MENU> button while the thumbnail screen is displayed.
The menu is displayed.
6
In the [THUMBNAIL] menu → [PLAYBACK] → [CLIP SEL], select the card slot of the memory card to play back.
[ALL SLOT]: Displays all the clips recorded on every memory card in each card slot.
Displays in the order of the clips in the card slot 1, clips in the card slot 2, and then clips in the card slot 3 when MOV is selected as the recording file
format.
Displays the clips on all the memory cards in the order of the recording date and time when P2 is selected as the recording file format.
[SLOT1]: Displays only the clips recorded on the memory card in card slot 1.
[SLOT2]: Displays only the clips recorded on the memory card in card slot 2.
[SLOT3]: Displays only the clips recorded on the memory card in card slot 3.
[SAME FORMAT]: Displays only the clips recorded in the same format as the system format.
Clips recorded in the same format match the current settings for each item of the [SYSTEM] menu → [FREQUENCY]/[FILE FORMAT]/[REC
FORMAT].
7
Select the clip to play back. (Fig. 1)
f is displayed on the clip that cannot be played back.
f To play back the clip with
Chapter 6 Playback — Thumbnail operation
ALL SLOT
displayed, check the information of the clip with the clip information, and try operating from the beginning again.
P2 MOV 1 2
Fig. 1
– 173 –
3 14.6V