How To Install - Danfoss VLT AutomationDrive FC 301 Operating Instructions Manual

®
VLT AutomationDrive FC 300 Operating
Instructions

3 How to Install

3.1.1 About How to Install
This chapter covers mechanical and electrical installations to and from power terminals and control card terminals.
Electrical installation of options is described in the relevant Operating Instructions and Design Guide.
Read the safety instructions before installing the unit.
3.1.2 Checklist
When unpacking the frequency converter, ensure that the unit is undamaged and complete.
Mechanical Dimensions
For power ratings, please see
A selection of screwdrivers (phillips or cross-thread screwdriver and torx), a side-cutter, drill and knife is also recommended to have handy for unpacking
and mounting the frequency converter. The packaging for these enclosures contains, as shown: Accessories bag(s), documentation and the unit. De-
pending on options fitted there may be one or two bags and one or more booklets.
Illustration 3.1: Diagram showing basic installation including
mains, motor, start/stop key, and potentiometer for speed
adjustment.
table on the next page
®
MG.33.AG.02 - VLT is a registered Danfoss trademark
3 How to Install
3
15