Danfoss VLT AutomationDrive FC 301 Operating Instructions Manual page 51

®
VLT AutomationDrive FC 300 Operating
Instructions
1-93 Thermistor Source
Option:
[0] * None
[1] Analog input 53
[2] Analog input 54
[3] Digital input 18
[4] Digital input 19
[5] Digital input 32
[6] Digital input 33
NB!
This parameter cannot be adjusted while the motor is running.
NB!
Digital input should be set to [0]
Function:
Select the input to which the thermistor (PTC sensor) should be connected. An analog input option
[1] or [2] cannot be selected if the analog input is already in use as a reference source (selected in
Reference 1 Source
par. 3-15 , par. 3-16
None
When using MCB 112, choice [0]
PNP - Active at 24V
in par. 5-00.
®
MG.33.AG.02 - VLT is a registered Danfoss trademark
4 How to Programme
Reference 2 Source Reference 3 Source
or par. 3-17
must always be selected.
4
).
51