How To Read These Operating Instructions - Danfoss VLT AutomationDrive FC 301 Operating Instructions Manual

®
VLT AutomationDrive FC 300 Operating
Instructions

1 How to Read these Operating Instructions

These Operating Instructions can be used for all VLT AutomationDrive frequency converters with software version 6.0x.
The software version number can be seen from par. 15-43
1.1.1 How to Read these Operating Instructions
VLT AutomationDrive is designed to provide high shaft performance on electrical motors. Please read this manual carefully for proper use. Incorrect
handling of the frequency converter may cause improper operation of the frequency converter or related equipment, shorten lifetime or cause other
troubles.
These Operating Instructions will help you get started, install, program, and troubleshoot your VLT AutomationDrive.
The VLT AutomationDrive comes in twoshaft performance levels. FC 301 ranges from scalar (U/f) to VVC+ and handles asynchronous motors only. FC
302 is a high performance frequency converter for asynchronous as well as permanent motors and handles various kinds of motor control principles such
as scalar (U/f), VVC+ and Flux vector motor control.
These Operating Instructions cover both FC 301 and FC 302. Where information covers both series, we refer to VLT AutomationDrive. Otherwise, we
refer specifically to either FC 301 or FC 302.
Chapter 1, How to Read these Operating Instructions, introduces the manual and informs you about the approvals, symbols, and abbreviations
used in this literature.
Chapter 2, Safety Instructions and General Warnings, entails instructions on how to handle the FC 300 correctly.
Chapter 3, How to Install, guides you through mechanical and technical installation.
Chapter 4, How to Programme, shows you how to operate and programme the FC 300 via the LCP.
Chapter 5, General Specifications, contains technical data about FC 300.
Chapter 6, Troubleshooting, assists you in solving problems that may occur when using FC 300.
Available Literature for FC 300
- The VLT AutomationDrive Operating Instructions provide the necessary information for getting the drive up and running.
- The VLT AutomationDrive Design Guide entails all technical information about the drive design and applications including encoder, resolver and
relay options.
- The VLT AutomationDrive Programming Guide provides information on how to programme and contain all parameters of the frequency converter.
- The VLT AutomationDrive Profibus Operating Instructions provide the information required for controlling, monitoring and programming the
drive via a Profibus fieldbus.
- The VLT AutomationDrive DeviceNet Operating Instructions provide the information required for controlling, monitoring and programming the
drive via a DeviceNet fieldbus.
- The VLT AutomationDrive MCT 10 Operating Instructions provide information for installation and use of the software on a PC.
- The VLT AutomationDrive IP21 / Type 1 Instruction provides information for installing the IP21 / Type 1 option.
- The VLT AutomationDrive 24 V DC Backup Instruction provides information for installing the 24 V DC Backup option.
Danfoss technical literature is also available online at www.danfoss.com/drives.
VLT AutomationDrive
Operating Instructions
Software version: 6.0x
Software Version
.
®
MG.33.AG.02 - VLT is a registered Danfoss trademark
1 How to Read these Operating Instructions
1
3