Recorder Section Adjustment; Lcd Pcb Setting Destination; Swp Adjustment; Fg Adjustment - Canon MVX200 E Service Manual

5-8 Recorder Section Adjustment

Note)
(1) Each of the adjustment data (5-8-1 to 5-8-3) becomes valid when 5-8-5 flash memory writing is made. When turning power OFF/
ON during each adjustment, be sure to carry out 5-8-5 flash memory writing.
Preparation)
(1) Except for the tape-path adjustment, carry out adjustment in the product state.

5-8-0 LCD PCB Setting Destination

When mounting the LCD P.C.B of service part, perform the following adjustment.
ST EP PROCEDURE
1 1) Make the setting shown at right.
2) Add "09" to the current value, and
store the result data.

5-8-1 SWP Adjustment

MODE Playback of color bar master (DY9-1381-000)
SPEC. Automatic adjustment
Procedure)
(1) While playing back the color bar master, carry out SWP automatic adjustment referring to the table shown below.
ST EP PROCEDURE
SWP (AUT O)
1 1) Make the setting shown at right.
2) Perform storing.
(press the PAUSE button.)
5-8-2 C. FG Adjustment
MODE Playback of color bar master (DY9-1381-000)
SPEC. Automatic adjustment
Procedure)
(1) While playing back the color bar master, carry out C.FG automatic adjustment referring to the table shown below.
ST EP PROCEDURE
C.FG(AUT O)
1 1) Make the setting shown at right.
2) Perform storing.
(press the PAUSE button.)
MONIT OR
CS Function MD ADDR DT
4 10 ST 0003 --
RD
ADJ
MONIT OR
CS Function MD ADDR DT
0 08 ST 0001 --
WR
↑ ↑ ↑ ↑
RD
MONIT OR
CS Function MD ADDR DT
0 08 ST 0003 --
WR
↑ ↑ ↑ ↑
RD
34
MVX250i E, MVX200i E, MVX200 E
SERVICE MODE · ADJUSTMENT
Microcomputer operation
Microcomputer operation
Automatic adjustment is in progress.
Automatic adjustment is completed.
Microcomputer operation
Automatic adjustment is in progress.
Automatic adjustment is completed.