Canon MVX200 E Service Manual page 132

<Note on Reassembling>
(1) Attach the GND Tape1 to the position indicated in the figure below.
(2) Attach the GND Tape2 to the position indicated in the figure below.
(3) Attach the Click Spring and the Cassette Arm Sheet as illustrated below.
(4) With the Cassette Arm Ass'y open, attach it to the dowel A of the Left Cover and then secure the screw.
<Instruction for Supply>
Click Spring, two dented spherical points : Hanal FL-778 (DY9-3026-010)
Note on Reassembling (1)
Left Cover
Attach the GND Tape1
so that it is secured to
the concave part of the
Left Cover.
(The GND Tape1 shall
not be unseated.)
Note on Reassembling (2)
Fold the hatched part to the back side.
(Fold through an angle 180 according to the shape of the cutout.)
Align with the end face of the left cover.
(Protrusion is not allowed.)
Instruction for Supply
Click Spring
Hanal FL-778
Note on Reassembling (3)
Click Spring
Cassette
Arm Ass'y
GND Tape1
Cassette
Arm Sheet
Stopper
Fig. 26
29
MVX250i E, MVX200i E, MVX200 E
Attach according to the outline
of the Cassette Arm Ass'y.
No interference with the Stopper
shall occur at the time of turning.
Allowable deviation of
attachment : ±0.5 mm.
GND Tape 2
Allowable deviation in attachment,
unless otherwise specified : ±0.5 mm.
Align the cutout part with the stepped
part of the left cover.
(Protrusion is not allowed.)
DISASSEMBLING