Canon MVX200 E Service Manual page 123

<Note on Reassembling>
(1) Slide the Jack2 Panel in the arrow direction to engage the dowel A with the claw B so that the Jack2 Plate is attached to the Jack2
Cover securely.
(2) Attach the GND Plate and LED Window as illustrated below.
(3) Attach the Cushion as illustrated below.
Note on Reassembling (1)
Note on Reassembling (2)
Insert part C of the
GND Plate under
the LED Window.
Note on Reassembling (3)
1. Insert the top end part A of the Cushion in the arrow
direction, and pull it outward as shown in the figure.
Jack2 Panel
Dowel A
Jack2 Cover
Claw B
2. Insert the part B of the Cushion into a gap between
LED Window
3. Align the end of the cutout part of the F Side Cover
GND Plate
Part C
4. Attach the Cushion by folding the parts E and F.
Fig. 17
MVX250i E, MVX200i E, MVX200 E
Peel-off sheet side
A
Cushion
the LED Window Cylinder and the CN51, and remove
the peel-off sheet from the Cushion.
CN51
B
Cushion
with the edge part C of the Cushion, align the end
face D with the wall face of the F Side Cover, and
attach the Cushion by turning the part B.
C
D
B
Cushion
F
E
Cushion
20
DISASSEMBLING
LED Window
A
Cylinder
LED Window
B
LED Window
D
C
B
LED Window
E
F