Separation Of Jack 2 P.c.b - Canon MVX200 E Service Manual

1-10 Separation of JACK 2 P.C.B.

(1) Detach the Cushion RC1 and RC2.
(2) Remove two screws (k × 2), disconnect the CN91, and detach the JACK2 P.C.B.
(3) Detach the CAV-JACK1 FPC and MAIN-JACK1 FPC from the CN701 and CN2101.
<Note on Reassembling>
(1) Before mounting the JACK2 P.C.B., run the MAIN-JACK1 FPC, CAV-JACK1 FPC, and MAIN-JACK1 Cable through groove A.
(2) Attach the Cushion RC1 and RC2 to the position indicated in the figure below.
Note on Reassembling (1),(2)
CAV-JACK1 FPC
MAIN-JACK1 FPC
MAIN-JACK1 Cable
k
2.5mm
Metal
M1.7
JACK2 P.C.B.
(2) - k
(2) - k
Cushion RC2
Cushion RC1
JACK2 P.C.B.
Cushion RC2
Align to the
Groove A
hole center.
1.5mm
Align to a point 1.5 mm above
the edge of the P.C.B.
Align to the outline
of the DV Connector.
Cushion RC1
(2)
CN91
(1)
(2)
(1)
Fig. 10
13
MVX250i E, MVX200i E, MVX200 E
CN2101
(3)
MAIN-JACK1 FPC
DISASSEMBLING
CN701
(3)
CAV-JACK1 FPC