Right Rail Internal Repairs; Removing The Inner Rail Assembly; Figure 7-25. Right Rail Disassembly - GE Giraffe OmniBed Carestation CS1 Service Manual

7.4.3 Right Rail Internal Repairs

7.4.3.1 Removing the Inner Rail Assembly

Refer to "Figure 7-24 Removing the Lift
Heater Door Cable
Side roller
bracket
1. Using a 2.5 mm hex key, remove the 2 screws located at either end of the upright in the rear dovetails
that secure belt channel to the inside of the upright. Using a 3 mm hex key, remove the side roller
bracket. Remove the lift motor coupler components if still attached to the rail assembly. Pull the entire
rail assembly up out of the upright.
2. Remove the pinch guard by sliding it up then pulling it off.
3. Remove the nut and washers at the bottom of the belt channel that secure the heater door opening rod
to the bracket and remove the assembly.
Service Manual
Motor",
Adjustment".
Access hole

FIGURE 7-25. Right Rail Disassembly

Right Rail Assembly Repair Procedures
"Figure 7-25 Right Rail Disassembly", and
Lift rail
Pinch guard
Buoyancy springs
Rollers
Belt block
Right upright
Chapter 7: Repair Procedures
"Figure 7-39
Belt channel
Motor bracket
7-23