All Profibus Dp And Profinet Io Fieldbus Couplers; Figure 29: Example Of The 750-375 And 750-377 Fieldbus Coupler Configuration Dialog; Table 49: Specific Module / Channel Parameters For 75X-652 - WAGO 750 Series Manual

76 Appendix

Figure 29: Example of the 750-375 and 750-377 fieldbus coupler configuration dialog

11.1.2.1

All PROFIBUS DP and PROFINET IO Fieldbus Couplers

The following assignment applies to the parameters of the I/O module when using
PROFIBUS-DP and PROFINET-IO fieldbus couplers.
Component damage due to incorrect voltage level!
Incorrectly selected voltage levels can destroy the device!
Note when switching between operating modes that RS-232 and RS-485 use
different voltage levels.
Switch off connected devices before changing operating modes!
Make sure that devices you connect support the voltage level of the current
operating mode!

Table 49: Specific module / channel parameters for 75x-652

GSD File
Description
Enhanced
operating mode
Mode
Value
according to the following
settings
DMX half-duplex/250k
RS-232
*)
RS-485 half-duplex
RS-422 full-duplex
Data exchange RS-422
WAGO-I/O-SYSTEM 750
750-652 Serial Interface RS-232 / RS-485
WAGO-I/O-CHECK
Selection box
Operating Mode
Operating Mode
Operating Mode
Operating Mode
Operating Mode
Operating Mode
Value
(no equivalent)
DMX half-
duplex/250k
RS-232
*)
RS-485 half-duplex
RS-422 full-duplex
Data exchange RS-422
Manual
1.2.0