Parameter Range; Figure 20: Parameter Range; Table 24: Parameter Range - WAGO 750 Series Manual

50 Commissioning
Pos : 82.4 /Serie 759 (WAGO-Softwar e)/WAGO-I/O-CHEC K/750- 0652 Seriell e Schnittstelle R S-232/RS- 485_Datenaus tausc hSeriell e Schnittstelle R S-232/RS- 485 750- 0652 (Parameter Ei nstellungen) @ 14\mod_1361196481276_21.doc x @ 112215 @ 3 @ 1
8.1.4

Parameter Range

Figure 20: Parameter range

The following selection boxes are displayed in tabular form. The possible settings
are described in more detail in the chapter "Operating Modes".

Table 24: Parameter range

Selection box
Operating Mode
Transmission Rate [Baud]
Data Bits
Parity
Stop bits
Flow Control
Continuous Send Mode
(Continuous Send)
Continuous Receive Mode
(Continuous Receive)
Switchover Time RS-485
Continuous Receive Timeout 2 Characters
*
Default setting
1)
The setting is relevant for the operating mode RS-232/RS-422, full-duplex.
2) The setting is relevant for the operating mode RS-232.
3)
The setting is relevant for the operating mode RS-485, half-duplex.
4)
Firmware version 03 or higher
750-652 Serial Interface RS-232 / RS-485
Possible settings
RS-232 / RS-485 half-duplex
/ data exchange RS-422
4)
duplex/250k
300 baud / 600 baud / 1200 baud / 2400 baud /
4800 baud / 9600 baud
38400 baud / 57600 baud / 115200 baud
*
8 / 7
*
none / odd / even
*
1 / 2
*
disabled / XON/XOFF
and follow-on time
*
disabled / release
*
disabled / release
3) *
100 us / 2 Characters / 4 Characters
*
/ 4 Characters
WAGO-I/O-SYSTEM 750
*
/ RS-422 full-duplex
4)
/ DMX half-
*
/ 19200 baud /
1) 2)
/ RTS/CTS / RTS, lead
4)
Manual
1.2.0