Changing The Pressure Filter - Toro 41393 Operator's Manual

Turf sprayer with excelarate spray system
Hide thumbs Also See for 41393:
Table of Contents

Advertisement

Changing the Pressure
Filter
Service Interval: Every 400 hours
1.
Move the machine to a level surface, shut off the
sprayer pump, shut off the engine, and remove
the key from the starter switch.
2.
Align a drain pan under the pressure filter
(Figure
94).
Figure 94
1. Filter head
2. O-ring (bowl)
3. Filter element
3.
Rotate the drain plug counterclockwise and
remove it from the bowl of the pressure filter
(Figure
94).
Note:
Allow the bowl to drain completely.
4.
Rotate the bowl counterclockwise and remove it
from its filter head
5.
Remove the old pressure-filter element
94).
Note:
Discard the old filter.
6.
Check the O-ring for the drain plug (located
inside the bowl) and the O-ring for the bowl
(located inside the filter head) for damage and
wear
(Figure
94).
Note:
Replace any damaged or worn O-rings
for the plug, bowl, or both.
7.
Install the new pressure-filter element into the
filter head
(Figure
Note:
Ensure that the filter element is firmly
seated into the filter head.
8.
Install the bowl onto the filter head hand tight
(Figure
94).
4. Bowl
5. O-ring (drain plug)
6. Drain plug
(Figure
94).
(Figure
94).
9.
Install the plug into the bowl hand tight
94).
g028235
73
(Figure

Advertisement

Table of Contents
loading

This manual is also suitable for:

Multi pro 5800-d

Table of Contents