Water Unit; Suction Handpieces; Hydrocolloid Coolant Supply - Sirona S2 Operating Instructions Manual

15 Water Unit

15
Water Unit
40
15.1
The vacuum system is switched on after a
suction hose is removed from the holder.
The suction power can be set via the assis-
tant unit control panel as described above
(see p. 38).
The suction handpiece can be angulated
by turning it.
ATTENTION! Should the vacuum sys-
tem switch off unintentionally, immedi-
ately remove the suction cannula from
the patient's mouth.
If the unit has no second saliva ejector hose
for the surgical cannula, the thick suction
hose must be used for surgical aspiration.
To insert a surgical cannula, please attach
the adapter supplied.
If the unit is equipped with a second saliva
ejector hose, the surgical cannula can be
inserted directly into the saliva ejector
handpiece.
15.2
If you want to work with a hydrocolloid
coolant supply, you can obtain an adapter,
1
Order No: 33 15 814 free of charge with the
enclosed voucher.
Please state your address and enter the
Serial No. of the chair (see unit pass).
The adapter can be connected to the
cuspidor as follows:
Pull out the tumbler outlet (1) turning it
slightly at the same time and plug the
adapter (2) into the self-closing valve until it
snaps into place. Press the locking clip (3)
before pulling out the connecting piece.
2 3
Sirona Dental Systems GmbH

Suction Handpieces

Hydrocolloid Coolant
Supply
41 63 189 D 3311
D 3311.201.01.10.02