Patient Positions, Program Selection - Sirona S2 Operating Instructions Manual

Sirona Dental Systems GmbH
6

Patient Positions, Program Selection

41 63 189 D 3311
D 3311.201.01.10.02
6 Patient Positions, Program Selection
WARNING!
The patient's arms and legs must
remain resting on the chair upholstery
during the program run!
NOTE: The built-in safety circuit stops all
chair movements if the bottom of the seat ∆
or the backrest ∆ οr the headrest ∆ collides
with any obstacle.
The chair will then automatically travel
upwards a little to free the obstacle.
Keys for selecting programmed patient
positions.
Factory setting:
The unit lamp switches OFF automatically
before the movement into the neutral posi-
tion 0 or in the mouth rinsing position S.
The unit lamp switches ON automatically
after reaching the patient position 1 or 2.
Changing the factory setting:
It is possible to preselect when program-
ming the patient positions whether the unit
lamp should switch OFF or ON in the differ-
ent chair programs 0, S, 1 or 2
(see page 18).
TRAVEL STOP!
All workstation travel movements will
be disabled if any chair control key is
pressed during automatic travel to a
programmed position.
At the same time, a double-beep warning
signal is sounded.
15