Surgery With Saline Solution Nacl - Sirona S2 Operating Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

Sirona Dental Systems GmbH
13

Surgery with Saline Solution NaCl

41 63 189 D 3311
D 3311.201.01.10.02
13 Surgery with Saline Solution NaCl
Preparation of unit
Hang NaCl bottle (1) in place.
Attach peristaltic pump set (2).
Push short end of hose (3) with cannula
as shown through stopper and into
NaCl bottle.
The regulator in the hose clip (4) must
be in the top position (completely
open).
Run long hose (5) along corresponding
motor hose up to the angle piece and
fasten with clips (6).
Fit coupling (7) onto hose and connect
it with thin silicone hose (8).
Connect spray clip (9) with thin hose
and attach to angle piece.
The peristaltic pump set (2) is a
disposable article, it can be purchased as
consumable material under the article num-
ber F 58707 directly from the manufacturer
in packs of 10 pcs.
Purchase address:
Fa. Satelec
Industriestr. 9
40822 Mettmann
NOTE
Preselection of the hanger for the
instrument with saline solution is described
under "Basic Workstation Settings with
Mode Key" on p. 32.
After a handpiece is removed from its
hanger, the NaCl pump can be switched
ON/OFF by pressing the with/without
spray key (or footswitch towards the left).
When the green LED of the key lights up,
the NaCl pump is switched ON.
37

Advertisement

Table of Contents
loading

Table of Contents