Installing The Keyboard - IBM 3746-900 Installation And Maintenance Manual

|
1-14
3745-XXA 1-14 3746-9X0: 6578 SPIM
Figure 1-9. Installing the Keyboard
16. Obtain a table or a desk large enough to receive the Service Processor, the
display, the keyboard, and the modem, and go to step 17.
17. Connect the cables to the 6578 as follows (see Figure 1-10 on page 1-15):
a. Connect the keyboard cable A to the connector at the rear of the Service
Processor.
b. Connect the mouse cable B to the connector at the rear of the Service
Processor.
Note: If you are installing the keyboard and the mouse outside of the
controller expansion, use the keyboard extender cable PN 10K8632 G
and the mouse extender cable PN 10K8633 H (see Figure 1-11 on
page 1-15).
c. Connect the Service Processor power cord C .
d. Connect the token-ring cable D (PN 6339098) to the Service Processor
connector.
e. Connect the display signal cable F to the Service Processor connector.
Note: If you are installing the display outside of the controller expansion,
use the extender cable PN 59G1270 (see Figure 1-11 on page 1-15,
reference J ).
f. After you secure all these connections, plug the power cords into
properly grounded electrical outlets.