IBM 3746-900 Installation And Maintenance Manual page 157

FIXED DISK TEST CATEGORY (6/15)
Controller
Hi-Low
Funnel Seek
Track to Track Seek
Random Seek
Linear Verify
Random Verify
SMART
Start Track
End Track9999
Default
Clear All - Run Screen - Run All - Options - Next Cat - Prev Cat
9. Select Clear All to remove all the chevrons >>.
10. With the arrow keys and the space bar select the test that you want to run on
the disk. At each selection a chevron >> is displayed.
11. Select Run Screen at the bottom of the panel to start all the tests previously
selected.
When the hard disk drive has been successfully tested, the Fixed Disk Test
Category panel is again displayed. The test result appears in front of each
selected test.
12. Is the diagnostic error-free?
No Restart the problem determination.
Yes You must restore the Service Processor hard disk after its
replacement. Continue with step 13.
13. Press Esc for exit from the test panel.
14. Select Quit in the title bar, then press Enter.
15. Select Exit Diags, then press Enter.
16. Remove the diagnostic diskette.
17. Install the Service Processor Installation Diskette 1 in the diskette drive (verify
that write is enabled).
18. Install the CD-ROM that contains the latest version of the LIC in the drive.
19. Simultaneously, press the Ctrl-Alt-Del keys on the keyboard.
20. When the IBM logo is displayed press Enter.
21. The following panel is displayed:
You are going to restore the SP hard disk from the CD-ROM.
During this procedure, you will be prompted to insert the
configuration parameter diskette.
Before proceeding:
- Ensure that this diskette contains the latest customer
configuration parameters.
- Press enter to proceed or escape to exit.
Press Enter.
Disk 0 Disk1 Disk2
13579 MB
>>
>>
>>
>>
>>
>>
>>
>>
0
ProPf PC: 1 lagleft:6936
Chapter 5. Service Processor FRUs / Display Exchange
Disk3
5-13