Cd-Rom Drive Removal - IBM 3746-900 Installation And Maintenance Manual

CD-ROM Drive Removal

|
|
|
Power Supply Removal
H-4
3745-XXA H-4 3746-9X0: 6578 SPIM
To remove the CD-ROM drive:
1. Swing the 5.25-in. drive cage up and out.
2. Remove the two screws that hold the CD-ROM drive in place. Lift the
CD-ROM drive out of the cage.
Note: When connecting the CD-ROM Audio Cable, make sure the cable is routed
along the system board near the PCI adapter slots. Continue routing the cable
along the system board between the power connector and primary IDE connector
and then up to the CD-ROM drive. Do not route the CD-ROM cable near the
system board I/O connectors.
Note: Make sure the power supply voltage switch is set to the proper operating
voltage: 115 or 230.
To remove the power supply:
1. Remove the top cover.
2. Remove the air duct.
3. Disconnect the power supply connectors.
4. Remove the four screws that hold the power supply to the back of the chassis.