Hard Disk Drive Exchange - IBM 3746-900 Installation And Maintenance Manual

Hard Disk Drive Exchange

|
|
|
5-6
3745-XXA 5-6 3746-9X0: 6578 SPIM
5. Install the plastic air baffle on the top of the processor to prevent processor
overheating.
6. Reinstall the Service Processor cover.
7. Go to "After FRU Exchange" on page 5-9.
1. Swing the 3 1/2-in. drive cage up, and latch it to the vertical position.
2. Press the two side rail tabs and push the hard drive from the bottom. Pull the
hard disk drive out.
3. Unpack the new hard disk drive.
4. Check the jumper settings on the new hard disk drive and set them to
correspond to the old hard disk drive settings. Otherwise, see "Hard-Disk Drive
Jumper Settings" on page 3-30.
5. Replace the drive cage into its horizontal position, being careful to place the
cage latch back to its regular horizontal position. This is necessary so that the
machine cover will fit correctly.
6. Reinstall the Service Processor cover.
7. Go to "After FRU Exchange" on page 5-9.