Point-To-Point Protocol Configuration - IBM 3746-900 Installation And Maintenance Manual

26. On the Java Customization panel, enter or select the following options:
a. Click No to reject any incoming call.
b. Enter the local phone number, which is the phone number of the modem
connected to the SP.
c. The IP addresses of:
1) The PPP-server. This is PPP address of the Service Processor.
2) The PPP-client. This is PPP address of the remote station.
Note: These IP addresses must be in the same subnet than the IP
addresses of the units connected to the service LAN, see the worksheet
"Parameter Definitions for Point-to-Point Link Definition" on page C-5.
d. The DTE speed, which must be set according to the type of the modem
installed (click Help for more details).
Then, click Next>>. The Console Configuration for Java panel appears.
Figure 1-45. Point-to-Point Protocol Configuration
Chapter 1. Installing and Setting Up Your Service Processor
1-47