Other Frus Exchange - IBM 3746-900 Installation And Maintenance Manual

|
|
|
|
|

Other FRUs Exchange

After FRU Exchange
Note: If you are installing a Wake on LAN-supported network adapter, attach
the Wake on LAN cable that came with the adapter to the Wake on LAN
connector on the system board. If you also want to take advantage of the Alert
on LAN feature of the computer, you must install the network adapter in PCI
slot 1.
9. Install the retainer and secure it with the screw previously removed.
10. Plug the cable previously removed to the rear of the adapter card.
11. Reinstall the Service Processor top cover.
12. Go to "After FRU Exchange."
1. Locate the FRU to exchange.
2. With the help of figures given in "Computer Exploded View" on page H-1
remove the FRU.
3. Unpack and install the new FRU.
4. Reinstall the Service Processor top cover.
5. Go to "After FRU Exchange."
1. For setting up the Service Processor after FRU exchange use the following
steps:
a. If the Service Processor was installed in a controller expansion, continue
with step 1b. Otherwise, go to step 1c.
b. Slide the Service Processor into the controller expansion.
c. At the rear of the Service Processor reconnect all the cable previously
removed.
2. Use Table 5-2 to find the procedure you need to follow after exchanging an
FRU.
Table 5-2. FRU Exchange Procedures
Service Processor
FRU to Exchange
Battery
Board
Hard Disk Drive
Token-Ring Adapter
Other FRUs
Action
Go to "After Battery or Board Exchange" on page 5-10.
Go to "After Hard Disk Drive Exchange" on page 5-12.
Go to "After Token-Ring Adapter Card Exchange" on
page 5-10.
Go to "After Other FRU Exchanges" on page 5-15.
Chapter 5. Service Processor FRUs / Display Exchange
5-9