After Battery Or Board Exchange - IBM 3746-900 Installation And Maintenance Manual

After Battery or Board Exchange

|
|
|
|
|
|
After Token-Ring Adapter Card Exchange
|
|
5-10
3745-XXA 5-10 3746-9X0: 6578 SPIM
Go through the following steps after a battery or board exchange.
1. Power on the Service Processor and its attached display.
2. Press the F1 key to invoke the Configuration/Setup utility after POST
completion.
3. Use "Service Processor Configuration Reference Based on 6578-RAU" on
page H-8 to check this configuration and to correct it, if necessary.
4. At the end of configuration, if you performed some modifications, a message
asks you if you want to save your changes. Select Yes and press Enter.
5. If you have changed the board, go to step 6. Otherwise, if you have changed
the battery, go to Chapter 6, "CE Leaving Procedure" on page 6-1.
6. Run diagnostics on the Service Processor see "Starting the IBM PC Enhanced
Diagnostics Program" on page 4-4.
7. Is the diagnostic error-free?
No Restart the problem determination.
Yes Return the Service Processor to the customer, then go to
Chapter 6, "CE Leaving Procedure" on page 6-1.
Go through the following steps after token-ring adapter card exchange.
1. Insert the Token-Ring Adapter Card Configuration diskette (PN 10K8634) in the
Service Processor.
2. Power on the Service Processor and the attached display.
3. Wait until the following panel appears:
PC DOS 7.0 Startup Menu
1- IBM Token-Ring PCI Adapter Configuration using LANAIDC
2- IBM Token-Ring Adapter Extended Diagnostics for 4/16 Mbps
3- IBM Token-Ring Adapter Extended Diagnostics for 100 Mbps
Enter a choice: 1 Time remaining: xx
Hit any key to continue with LANAIDC from diskette or remove diskette
and reboot system normally
4. Press any key on the keyboard. The following lines are added to the previous
panel.
Enter LANAID parameters - reboot your machine when done
Examples: /View
/Help
LANAIDC >
5. Enter /VIEW
6. A panel indicating the current setting appears: