Ibm Pc Enhanced Diagnostic Error Codes - IBM 3746-900 Installation And Maintenance Manual

IBM PC Enhanced Diagnostic Error Codes

Refer to the following Diagnostic Error Codes when using the IBM PC Enhanced
Diagnostics test. See "Diagnostics Test Programs" on page 4-3 for information
about the IBM PC Enhanced Diagnostics program.
In the following index, X can represent any number.
Diagnostic Error Code
000-000-XXX
BIOS Test Passed
000-002-XXX
BIOS Timeout
000-024-XXX
BIOS Addressing test failure
000-025-XXX
BIOS Checksum Value error
000-026-XXX
FLASH data error
000-027-XXX
BIOS Configuration/Setup error
000-034-XXX
BIOS Buffer Allocation failure
000-035-XXX
BIOS Reset Condition detected
000-036-XXX
BIOS Register error
000-038-XXX
BIOS Extension failure
000-039-XXX
BIOS DMI data error
000-195-XXX
BIOS Test aborted by user
000-196-XXX
BIOS test halt, error threshold exceeded
FRU to replace/action to take
No action
1. Flash the system.
2. System board
1. Flash the system.
2. System board
1. Flash the system.
2. Boot block
3. System board
1. Flash the system.
2. Boot block
3. System board
1. Run Setup.
2. Flash the system.
3. Boot block
4. System board
1. Reboot the system.
2. Flash the system.
3. Run memory test.
4. System board
1. Flash the system.
2. System board
1. Flash the system.
2. Boot block
3. System board
1. Flash the system.
2. Adapter card
3. System board
1. Flash the system.
2. System board
1. Information
2. Restart the test, if you need to.
1. Press F3 to review the log file. See
"Viewing the Test Log" on
page 4-8.
2. Restart the test to reset the log file.
Chapter 4. Service Processor Diagnostics and Test Information
4-9