IBM 3746-900 Installation And Maintenance Manual page 155
Service processor (based on 6578)
Hide thumbs
Also See for 3746-900:
- Installation manual (276 pages) ,
- Connection and integration manual (166 pages) ,
- Installation instructions manual (10 pages)
Table of Contents
Advertisement
| |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
Current Adapter Setting
Adapter Number:
Adapter MAC Address: xx x xx xx x xx
Microcode Level
I/O Address:
Interrupt:
Latency Timer:
Remote IPL:
Expansion ROM:
LANAIDC>
* Changes to RIPL and EXPROM will not be reflected until reboot.
Note: If the Remote IPL parameter and the Expansion ROM parameter are
not set as described above, use the following commands to correct them:
/RIPL=N
to disable the Remote IPL feature.
/EXPROM=Y
to enable the Expansion ROM feature.
7. Remove the diskette.
8. Power OFF the Service Processor
9. Power ON the Service Processor
10. Press the F1 key to invoke the Configuration/Setup utility after POST
completion.
11. Use "Service Processor Configuration Reference Based on 6578-RAU" on
page H-8 to check this configuration and to correct it if necessary.
12. At the end of the configuration, if you performed some modifications, a
message asks if you want to save your changes. Select Yes and press Enter.
13. Go to Chapter 6, "CE Leaving Procedure" on page 6-1.
1
yyyyyy zzzzzz
7400
10
48
Disabled*
Enabled*
Chapter 5. Service Processor FRUs / Display Exchange
5-11
Advertisement
Table of Contents
