Token-Ring Adapter Card Exchange - IBM 3746-900 Installation And Maintenance Manual

|
|
|

Token-Ring Adapter Card Exchange

|
|
|
|
|
|
5-8
3745-XXA 5-8 3746-9X0: 6578 SPIM
3. Unpack the new diskette drive.
4. Replace the drive cage into its horizontal position, being careful to place the
cage latch back to its regular horizontal position. This is necessary so that the
machine cover will fit correctly.
5. Reinstall the Service Processor cover.
6. Go to "After FRU Exchange" on page 5-9.
The Service Processor has four expansion slots used to connect adapters to the
peripheral component interconnect (PCI) bus.
1. Locate the token-ring adapter card that must be exchanged.
2. Unplug the cable from the rear of the adapter card.
3. Remove the screw that maintains the retainer on the rear of the computer.
4. Unplug the adapter card from the system board.
5. Remove the new adapter card from its static-protective package.
6. Remove the metal I/O bracket from the adapter slot.
7. Install the adapter in the appropriate slot on the system board.
8. Install the adapter slot cover latch. Pivot the latch back to a horizontal position.