Step 7: Customizing Your Service Processor - IBM 3746-900 Installation And Maintenance Manual

Step 7: Customizing Your Service Processor

Notes:
1. For any unexpected message or error concerning the Service Processor, go to
"MAP: Entry Point for Problem Isolation" on page 2-1. For any other message
or error displayed on the control panel go to:
The START page of the 3745 Communication Controller Models 210 to
61A Maintenance Information Procedures, SY33-2054, if you are working
on a 3745 Model X1A.
The START page of the 3745 Communication Controller Models 130 to
17A Maintenance Information Procedures, SY33-2070, if you are working
on a 3745 Model 17A.
The START page of the 3746-900 Service Guide, SY33-2116, if you are
working on a 3746-900.
Or go to the START page of the 3746-950 Service Guide, SY33-2108, if
you are working on a 3746-950.
2. The purpose and explanation for the different parameters is given in the 3745
Communication Controller Models A and 3746 Models 900 and 950: Planning
Guide, GA33-0457.
3. Ensure that the machine type and model are registered in RETAIN (CCPF).
For U.S.A. machines, please call the Raleigh Multiplexor Support Center and
verify your machine's registration in CCPF. Make sure that:
a. The seven-digit serial number of the 3745/3746 is correct.
b. The three-digit model designation for the 3745/3746 is correct.
1. Power ON the display.
a. Turn on your display, and adjust the Brightness and Contrast controls to
the approximate midpoint.
You can readjust these controls for personal viewing comfort after you turn
on your Service Processor.
Note: The locations of the power switch and the Brightness and Contrast
controls on your display might be different from those shown above.
b. Adjust the keyboard feet for personal typing comfort.
Chapter 1. Installing and Setting Up Your Service Processor
1-33