Cd-Rom Drive Exchange - IBM 3746-900 Installation And Maintenance Manual

CD-ROM Drive Exchange

|
|
|
|
|
|
Diskette Drive Exchange
|
|
|
1. Swing the 5 1/4-in. drive cage up and out.
2. Remove the two screws that hold the CD-ROM drive in place. Lift the
CD-ROM drive out of the cage.
3. Unpack the new CD-ROM drive.
4. Check the jumper settings on the new CD-ROM drive and set them to
correspond to the old CD-ROM drive settings. Otherwise, see "CD-ROM,
PD/CD-ROM Drive Jumper Settings" on page 3-31.
5. Install and secure the new CD-ROM drive into the chassis using the two screws
previously removed.
6. Replace the drive cage into its horizontal position, being careful to place the
cage latch back to its regular horizontal position. This is necessary so that the
machine cover will fit correctly.
7. Replug the cables previously removed.
8. Reinstall the Service Processor cover.
9. Go to "After FRU Exchange" on page 5-9.
1. Swing the 3 1/2-in. drive cage up, and latch it to the vertical position.
2. Press the two side rail tabs and push the diskette drive from the bottom. Pull
the diskette drive out.
Chapter 5. Service Processor FRUs / Display Exchange
5-7