|
1-26
3745-XXA 1-26 3746-9X0: 6578 SPIM
4. Pressing the ↑ key, select the User Configuration Location where the current
modem configuration must be saved (0 to 9).
5. Press Enter to save the current modem configuration.
6. The defined configuration is now active and saved.
Every time the modem is reset (powered on), the last user configuration that was
saved is loaded as the current modem configuration.
Connecting the 7858
1. Plug the cable (PN 782984) into slot 1 of the Service Processor.
2. On the modem's rear panel, plug the other cable lead into the 25-pin connector
2 .
Figure 1-22. Connecting the Service Processor (6578) from COM1 to the 7858
If you received a controller expansion, go to step 3 , otherwise, go to "Step 7:
Customizing Your Service Processor" on page 1-33.
3. Slide the 7858 in the controller expansion as shown in Figure 1-23.
Figure 1-23. Installing the 7858 in the Controller Expansion
Go to "Step 7: Customizing Your Service Processor" on page 1-33 .