IBM 3746-900 Installation And Maintenance Manual page 168

DANGER
To avoid a shock hazard, do not
connect or disconnect any cables or
perform installation, maintenance, or
reconfiguration of this product during
an electrical storm.
To avoid shock hazard:
The power cord must be connected
to a properly wired and earthed
receptacle.
Any equipment to which this
product will be attached must also
be connected to properly wired
receptacles.
When possible, use one hand to
connect or disconnect signal cables to
prevent a possible shock from
touching two surfaces with different
electrical potentials.
Electrical current from power,
telephone, and communications cables
is hazardous. To avoid shock hazard,
connect and disconnect cables as
described following when installing,
moving, or opening covers of this
product or attached devices.
A-6
3745-XXA A-6 3746-9X0: 6578 SPIM
To Connect
1. Turn Everything
OFF.
2. First, attach all
cables to devices.
3. Attach signal cables
to receptacles.
4. Attach power
cord(s) to outlet.
5. Turn device ON.
NOTE: In the UK, by
law, the telephone
cable must be
connected after the
power cord.
To Disconnect
1. Turn Everything
OFF.
2. First, remove power
cord(s) from outlet.
3. Remove signal
cables from
receptacles.
4. Remove all cables
from devices.
NOTE: In the UK, the
power cord must be
disconnected after the
telephone cable.