Byte; Legend - Pepperl+Fuchs IC-KP-B7-V95 Manual

Identcontrol interface with devicenet interface
Table of Contents

Advertisement

IC-KP-B7-V95
Commands
IQH2-...:
IUH-...:
Note!
Toggle bit
If you send two commands with the same SystemCode and same ParamTyp in
succession on the bus interface, you must change the toggle bit in the second
command in order for the node to detect the command.
7.5

Legend

<Battery condition 1> : 1 byte, first digit of battery status (percentage, decimal, ASCII
<Battery condition 2> : 1 byte, second digit of battery status (percentage, decimal, ASCII
<Battery condition 3> : 1 byte, third digit of battery status (percentage, decimal, ASCII
<ByteNum>
<Channel>
<ConfAddr>
<Data>
<F>
<Fill Sign>
<FixLen>
<FixType>
<IDCode>
<Ident channel>
<SystemCode>
=
'Q' ASCII (51
<ParamTyp>
=
'K1' ASCII (4B
RP: reads the key (12 characters ASCII from 0 ... F)
from the transponder and the read head
WP: writes the key (12 characters ASCII from 0 ... F)
into the read head
Default key = 'FF FF FF FF FF FF' ASCII
(46
See handbook of the read / write head
encoded). 30h, 31h
encoded). 30h, 39h
encoded). 30h, 39h
: 4 bits, length of <ID code>;
System MV: 4 characters (04h)
System IQ: 8 characters (08h)
: 3 bits, channel
Channel 1 (001b), channel 2 (010b),
channel 3 (011b), channel 4 (100b), all channels (111b)
: 1 ASCII character, word starting address in configuration
area of data carrier. The following applies for IPC03:
01h = Protection Word
02h = Control Word
: <WordNum> times 4 bytes. When communicating a word,
the highest value byte is transferred first and the lowest
value byte last.
: 1 bit, multiplex mode, 0 (0b): Mode off, 1 (1b): Mode on
: 1 ASCII character
: 4 bits, length of the read only code in bytes, see "This command tells
the read/write head on the relevant channel which tag type to
communicate with. This setting is stored in the non-volatile memory
on the unit." on page 33
: 2 ASCII characters, for example: '02' for IPC02
: 4 bytes, 6 bytes or 8 bytes (depending on the tag type)
: 3 bits, channel
1 (001b), 2 (010b), 3 (011b), 4 (100b), all channels (111b)
(but not <Sensor channel> in trigger mode)
)
h
31
)
h
h
46
46
46
46
46
46
46
46
h
h
h
h
h
h
h
h
46
46
46
)
h
h
h
h
65

Advertisement

Table of Contents
loading

Table of Contents