Adjusting The Robacta Reamer Twin Lifting Device; Adjusting The Lifting Device - Fronius Robacta Reamer Alu Edition Manual

Adjusting the Robacta Reamer Twin lifting device

Adjusting the lift- It is recommended that one of the following adjustment aids is used to adjust the lifting de-
ing device vice:
- Robacta Twin 900 adjustment aid, item no. 42,0001,5560
(4) (4)
Remove protective covering (1)
1
Ensure that the lifting device is in its lo-
2
west position
Loosen screw (2) on the lifting device
3
Move welding torch to cleaning positi-
4
on (including fitted adjustment aid)
Push the lifting device (3) by hand into
5
(1) (1)
its highest position and hold in place
(2) (2)
(3) (3)
Manually push cleaning motor (4) and
6
cleaning cutter to the cleaning position
(5)
(5) (5)
NOTE!
The cleaning cutter must not touch any
welding torch parts.
Fix cleaning motor (4) in this position in
7
the lifting device - tighten screw (2) on
the lifting device
Fit the protective covering to the clea-
8
ning device in its original position
47