Adjusting The Robacta Reamer Alu Edition Lifting Device; Adjusting The Lifting Device - Fronius Robacta Reamer Alu Edition Manual

Adjusting the Robacta Reamer Alu Edition lifting de-
vice
Adjusting the lift-
ing device
5
6
7
8
9
2/3 2/3
1/3 1/3
(5) (5)
Push the lifting device (3) by hand into its highest position and hold in place
Manually push cleaning motor (4) and cleaning brush to the cleaning position
- see diagram (5) - correct adjustment
- see diagram (6) - incorrect adjustment
Fix cleaning motor (4) in this position in the lifting device (3) - tighten screw (2) on the
lifting device
Carry out function test - push lifting device by hand to its highest position
- Check that lifting device is adjusted correctly - see diagram (5). If the correct ad-
justment is not given, readjust the lifting device
Fit the protective covering to the cleaning device in its original position
Remove protective covering (1)
1
Ensure that the lifting device is in its lo-
2
west position
Loosen screw (2) on the lifting device
3
Move the welding torch to the cleaning
4
(1) (1)
position
(2) (2)
(4) (4)
(2) (2)
(3) (3)
(6) (6)
45