Adjusting The Robacta Reamer Alu 3000Upm Lifting Device; Adjusting The Lifting Device - Fronius Robacta Reamer Alu Edition Manual

Adjusting the Robacta Reamer Alu 3000upm lifting
device
Adjusting the lift-
ing device
The cleaning cutter must not touch any welding torch components.
8
9
10
11
12
46
(5) (5) (6) (6)
NOTE!
Fix cleaning motor (4) in this position in the lifting device (3) - tighten screw (2) on the
lifting device
Carry out function test on unfitted gas nozzle - push lifting device by hand to its highest
position
- The cleaning cutter must close around the contact tip without touching it. If the
cleaning cutter touches welding torch components, readjust the lifting device
Fit gas nozzle to torch neck
Carry out function test on fitted gas nozzle - push lifting device by hand to its highest
position
- The cleaning cutter must be inserted into the gas nozzle gently, without touching
it. If the cleaning cutter touches welding torch components, readjust the lifting de-
vice
Fit the protective covering to the cleaning device in its original position
Remove protective covering (1)
1
Remove gas nozzle from torch neck
2
Ensure that the lifting device is in its lo-
3
west position
Loosen screw (2) on the lifting device
4
Move the welding torch to the cleaning
5
position
Push the lifting device (3) by hand into
6
its highest position and hold in place
Manually push cleaning motor (4) and
7
cleaning cutter to the cleaning position
- see diagram (5) for welding torch
and spatter guard
(4) (4) - see diagram (6) for welding torch
and insulating sleeve
(2) (2)
(3) (3)