Saving Configuration Changes To Flash Rom - Digi PortServer II User Manual

Saving configuration changes to flash ROM

Each set command includes an option to save configuration changes into PortServer
II's Flash Read Only Memory (ROM). If you logged in as root, save is on by default.
If you are not logged in as root, save is off by default.
Important: Changes made by a non-root user are valid only for the duration of their
session.
Non-root users can only set parameters for their own port. If non-root users wish to
save their parameters in Flash ROM, the configuration command must include
save=on. The System Administrator must also configure this port with set logins
write=on.
Since configuration changes are automatically saved for root users, you must remem-
ber to add save=off to any temporary changes you make when logged in as root.
90030500B Basic Configuration Page 59