Dialer Messages - Digi PortServer II User Manual

11) <name> failed verify
The user is incorrectly configured. Use the wan verify command to find out why.
12) <name>: bad value for access time
The access time during which the user can start a connection has a syntax error.
13) can't create route for interface=<name> (<reason>)
This message indicates a route cannot be set up for this user (probably an internal
error).
14) adding route for <name> (<network>) failed(<reason>)
The route indicated by the user's IP mask could not be created.
15) Connection <name> aborted; port <port> not set up for Frame Relay
Frame Relay is not enabled on the named port (see set frame).
16) no available port to start connection <name>
All ports that this connection is configured to use are busy.
17) <name>: verify failed, no outgoing network created
The user is incorrectly configured. Use the wan verify command to find out why.
18) <name>: interface already connected, failing new connection
An attempt was made to connect the same user twice.

Dialer messages

(Option=dialer)
1) receive failure while executing script <number>
*Internal error*
2) no phonenumber for script <name> state <num>, field <string>
A script requested a phone number when none has been configured.
3) chat parameters not defined for script <name> state <num>, field <string>
A script tried to use chat parameters where none have been defined.
Page 234 Troubleshooting 90030500B