Editing Keystrokes - Digi PortServer II User Manual

Editing keystrokes

You can use any of the following keystrokes when entering commands at the
PortServer II command line:
Ctrl + b Move the cursor left (move back)
Ctrl + f Move the cursor right (move forward)
--
Erase (delete character to the left of the cursor)
<
Delete Delete the character under cursor
Ctrl + h Delete the character to the left of the cursor. (You can change "h"
to another character with the set keys command, as described in
the Command Reference Guide.)
Ctrl+p When typed as the first character on a line, this sequence copies
the previous line from the command buffer onto the current line.
Ctrl+n When typed as the first character on a line, this sequence copies
the next line from the command buffer onto the current line.
Enter Executes the currently typed command.
Escape character. Used to break out of the current session, either
Ctrl [ Enter
to another session or to the PortServer II command line. (You can
change "[" to another character with the set keys command, as
described in the Command Reference Guide.)
Ctrl+c
Interrupt character. (You can change "c" to another character with
the set keys command, as described in the Command Reference
Guide.)
90030500B Basic Configuration Page 57