Monitor Serial Port Changes - Digi Connect IT 16 User Manual

Configure the Connect IT 16/48
Setting
Escape sequence
History size
Exclusive access
Idle timeout
5. Click Save or Apply.

Monitor serial port changes

You can choose to monitor CTS and/or DCD changes on the serial port.
1. Log in to manage the Connect IT.
2. Access the Configuration > Serial
3. Expand the port that you want to configure.
4. Expand the Monitor section.
5. Configure the settings.
Digi Connect IT® 16/48 User Guide
Description
The sequence of characters used to start an escape sequence.
Escape sequences allow a user to send control commands to
the serial port interface. These commands are removed from
the data stream and are not sent to the equipment connected
to the serial port.
If left blank, the escape sequence is disabled.
The default is a tilde (~).
An entry is optional.
Note This option is available only when Remote Access is
selected from the Serial mode list box.
The number of bytes from the serial port which should be
buffered. The buffered bytes are redisplayed when a user
connects to the serial port.
The minimum value is 0.
The default is 4000.
Note This option is available only when Remote Access is
selected from the Serial mode list box.
Select this option if access to the serial port should be limited
to a single active section. If not selected, multiple active
sessions are available on the port.
Note This option is available only when Remote Access is
selected from the Serial mode list box.
The length of time after which the active session is
disconnected after a period of user inactivity.
Syntax: number{w|d|h|m|s}
A setting of 0 disables idle timeouts.
The default is 15m.
Note This option is available only when Remote Access is
selected from the Serial mode list box.
screen.
Configure a serial port
27