State Parameters - Digi PortServer II User Manual

Immediately executes (uses) the text of state definition n as if it were
Un
inserted to replace this command. You can nest this command, up to a
maximum of 10.
Waits for a modem signal to become high. If m is 1, waits for DCD
W+m
high. If m is 2, waits for CTS high.
Waits for a modem signal to become low. If m is 1, waits for DCD
W-m
low. If m is 2 waits for CTS low.
[ string ] s Declares that a transfer to state s should be performed when string is
received on the communication line.

State parameters

You can use any of the following state parameters in place of s in the commands listed
above.
Transfer to state n, where n is a decimal number in the range 1 to 24.
n
Exit, indicating success.
+
Exit, indicating general failure.
-
Exit, indicating remote system is busy.
*
Exit, indicating remote system is down.
=
PortServer II take action(s) if any of these exit commands are issued. For example, a
retry timer is provided for both remote system busy and remote system down exit
conditions. Remote system busy causes PortServer II to try the next number in the
dialer script.
90030500B Configuring Modem Connections Page 131