Rlogin Session; Switching To Another Session - Digi PortServer II User Manual

Rlogin session

To leave an rlogin session and return to the PortServer II command line, enter:
Carriage Return ~ TESC Carriage Return
To switch to another rlogin session, enter:
Carriage Return ~ TESC <digit>
where <digit> is a valid active session number in the range 1-9.
To return to the previous session, enter:
Carriage Return ~ TESC TESC
To terminate the current session, enter:
Carriage Return ~ .

Switching to another session

To switch to another active session, type the session number as the first character of a
PortServer II command line. You do not have to press Carriage Return after
typing the number.
To go directly from one session to another without using the PortServer II command
line, type the telnet escape character followed by the number of the session you
require. For example, type the telnet escape character followed by 2 to go directly to
the second session.
Type the telnet escape character followed by Carriage Return to go from a ses-
sion to the PortServer II command shell.
As a shortcut, you can also toggle between your last two telnet sessions by pressing
Ctrl-] Ctrl-].
When you switch between sessions, the current session will continue on the next line
of your screen unless your terminal is capable of multiple screen operation (as
described later in this chapter). You may need to press the Carriage Return key
between sessions to see your prompt.
Page 98 Configuring Multiple Sessions and Multiple Screens 90030500B